Bt Board - Toshiba QOSMIO G10 Maintenance Manual

4 Replacement Procedures

4.16.2 BT board

Removing the BT board
The following describes the procedure for removing the BT board (See Figure 4-34).
1. Remove the following screw securing the battery connector cover and remove the
battery connector cover.
• M2.5×6.0B
2. Disconnect the BT board flat cable from the connector CN9691 on the BT board
and from the connector CN8021 on the system board.
3. Remove the following screw securing the BT board.
• M2.5×6.0B
4. Disconnect the battery harness from the connector CN9690 on the BT board and
from the connector CN8020 on the system board.
Battery connector cover
BT board flat cable
M2.5x6.0B FLAT BIND
QOSMIO G10 Maintenance Manual (960-497)
FLAT BIND screw
FLAT BIND screw
BT board
CN8021
Figure 4-34 Removing the BT board
4.16 RTC battery / BT board
x1
x1
M2.5x6.0B FLAT BIND
CN9690
Battery harness
CN8020
CN9691
4-51