Toshiba QOSMIO G10 Maintenance Manual page 300

4 Replacement Procedures
Installing the TV tuner module
The following describes the procedure for installing the TV tuner module (See Figure 4-48 to
4-50).
1. Insert the TV tuner module terminals slantwise into the connector CN2220 on the
system board.
2. Connect the TV tuner harness to the connector on the TV tuner module.
3. Connect the TV antenna cable to the connector on the TV tuner module.
4. Install the harness guide and secure it with the following screws.
• M2.0×6.0Z
5. Arrange the TV antenna cable along the harness guide.
6. Arrange the TV tuner harness along the guide and connect it to the connector
CN5661 on the system board.
7. Arrange the TJ board cable along the harness guide and connect it to the connector
CN5660 on the system board.
8. Connect the USB harness to the connector CN4613 on the system board and arrange
the cable along the harness guide.
TV antenna cable
Figure 4-50
QOSMIO G10 Maintenance Manual (960-497)
BIND screw
TV tuner harness
TJ board cable
Arranging cables on the harness guide
4.25 TV tuner module
x2
USB harness
4-71