Running Control Samples - Siemens ADVIA 1800 Operator's Manual

5. To remove any calibrators you do not want used in this run, select
select
To run only a reagent baseline (RBL) or blank rate, select only the blank solution.

Running control samples

1. Select
2. To remove any tests you do not want run on the controls, select
3. To remove any controls you do not want used in this run, select
From STT
1. Make sure the samples are loaded.
2. In the Ordinary sample area, next to Routine smp, select
This activates other fields.
3. To specify how the samples are identified, in the Ordinary sample area, next to
Analyze mode, select
If you select
You can choose to scan for a single tray position or for a range of positions as follows:
a. In the boxes to the right of Analyze, enter the range of positions you want to scan.
For example: If you enter
range and will aspirate only from positions at which it found barcodes.
b. If you want the system to aspirate sample from a specific position or specific
range of positions, select
c. Enter the tray number.
d. In the boxes to the right of Analyze, enter the position or range of positions from
where you want the system to aspirate samples.
4. Select
priority processing.
You can select more than one position at a time and to assign the same container type to
all.
5. To begin the run, select
From the optional universal rack handler or external transport
1. Select the second
2. To begin the run, select
3. Load the racks on the rack handler or the universal rack handler.
88
.
Control smp. Analyze .
Barcode
, the system scans the entire STT tray for barcodes.
Barcode
Cup posi
Temp.cup/tube select
Start .
General smp. Analyze
Start .
or
Cup posi.
50 and 60 . The system scans for barcodes within this
.
to change container types and select samples for
box (below Out side analyze).
Temp.sample
Temp.item select
Temp.sample select
Analyze .
ADVIA 1800 Operator's Guide
.
.