Software Overview; Startup Window - Siemens ADVIA 1800 Operator's Manual

Software Overview

CAUTION
This section of the manual describes the software windows available to configure and run
your chemistry system. It does not explain how to use these windows. For detailed
information on the use of the windows, refer to the online Operator's Guide.
The software controls most of the functions run by the chemistry system. The software,
which runs under the Windows operating system, starts automatically when you turn on
the PC.
You start the software from the Startup window, and stop it from the Menu Panel.
After the software has started, the Menu Panel and the Operation Panel appear at the top of
your screen.
As long as the software is running, these windows remain in the same position (unlike
most Windows XP windows). Use the top display option (Systems(s)) to allow other
windows to display on top of the Menu Panel and Operation Panel.

Startup window

The Startup window is the first window you see when you turn on the PC and the last
window when you stop the system.
Perform any of the following tasks at this window:
• new start
• restart
• back up and restore system files
• shut down and restart Windows XP
1. At the Menu Panel, select
2. When prompted, select
Windows restarts.
3. When prompted, press
4. At the Log on to Windows window, enter the Windows User name and Password.
5. Select
The Startup window opens.
If you select
able to perform the above functions). To open the Startup window again, restart Windows.
38
Load only Siemens-specified software onto your ADVIA Chemistry system PC to
avoid loss of data.
System(S)
Yes
Ctrl - Alt - Delete
OK .
, the Startup window closes, leaving you in Windows (you are not
Cancel
(to open the System menu), then select
, then select when prompted again.
Yes
.
Exit(X)
ADVIA 1800 Operator's Guide
.