Table of Contents
Advertisement
Force limiter
Read and observe
and
If there is an obstacle, the closing process is stopped and the window goes
down by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down
by several centimetres.
If you attempt to close the window again within 10 seconds of the window be-
ing moved down for the second time, even though the obstacle was not yet
been removed, the closing process is only stopped. During this time it is not
possible to automatically close the window. The force limiter is still switched
on.
The force limiter is only not operational if you attempt to close the window
again within the next 10 seconds – the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
WARNING
The front passenger window with the electric window has no force limiter.
The windows should nevertheless be closed carefully – risk of injury!
Operational faults
Read and observe
and
Repeatedly opening and closing the window can cause the window mechanism
to overheat and become temporarily blocked. You will be able to operate the
window again as soon as the operating mechanism has cooled down.
After disconnecting the vehicle battery, automatic opening/closing of the win-
dow can be deactivated. In this case, the system must be activated as follows.
Activating window operation
›
Switch on the ignition.
›
Pull the top edge of the button and close the window.
›
Release the button.
›
Pull up the respective button and hold for 1 second.
62
Operation
on page 60 first.
on page 60 first.
Lights and visibility
Light
Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
WARNING
For safety reasons, always set the light switch to the position as de-
fault setting.
The automatic driving lamp control only operates as a support and
■
does not release the driver from his responsibility to check the lights and, if
necessary, to switch on the light depending on the prevailing light condi-
tions.
Note
The headlights may mist up temporarily. When the light is on, the light-emit-
ting surface demists after a short time.
Operating the lights
Read and observe
on page 62 first.
Toswitch the lights on/off,turn the
positions (equipment-dependent).
Switching off lights (except daytime running lights)
Switching the light on/off automatically
Switching on the parking lights or parking lights on both sides
Switch on low beam
Fig. 57
Light switch and control dial for
headlight range adjustment
» Fig. 57
switch to one of the following
A
» page 64
» page 66
Advertisement
Table of Contents
