Table of Contents
Advertisement
Depending on the vehicle load, adjust the headlight range by turning the con-
troller
» Fig. 57
to the following positions.
B
Front seats occupied, boot empty
All seats occupied, boot empty
All seats occupied, boot loaded
Driver seat occupied, boot loaded
WARNING
Always adjust the headlight beam to meet the following conditions - other-
wise risk of accident.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
If, with a dipped beam, the ignition is turned off, then the dipped beam will
■
automatically switch off
and the parking lights illuminate. The parking lights
1)
are switched off when the ignition key is removed (for vehicles with the KES-
SY system, after opening the driver's door).
If there is a fault in the light switch, the low beam comes on automatically.
■
Daytime running lights(DAY LIGHT)
Read and observe
on page 62 first.
The daytime running light (hereinafter referred to as "function") lights the
front and rear vehicle area (only valid for some countries).
The lights are switched on automatically if the following conditions are
met.
The light switch is in the position or .
The ignition is switched on.
The function is activated.
Activating/deactivating function on vehicles with Infotainment
The function can be deactivated/activated in the Infotainment system in menu
→ → Light.
1)
Does not apply to the position , as long as the conditions are met for the COMING HOME function
» page
66.
Deactivating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push down and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audible
signal (about 3 s) can be heard.
Activating on vehicles without Infotainment
›
Turn off the ignition, pull the indicator/main beam lever towards the steering
wheel, push up and hold in this position.
›
Switch on the ignition and hold the lever in the above position until an audible
signal (about 3 s) can be heard.
WARNING
Always switch on the low beam when visibility is poor.
Turn signal/main beam
Read and observe
on page 62 first.
Control stalk positions
» Fig. 58
Switch on right turn signal
Switch on left turn signal
Switch on main beam (spring-tensioned position)
Switching off main beam / switching on headlamp flasher (spring-loaded
position)
The main beam can only be switched on when the low beam lights are on.
Fig. 58
Operating lever: Turn signal and
main beam operation
Lights and visibility
63
Advertisement
Table of Contents
