Removing/inserting the taillight
Fig. 276 Remove light / pull out connector
Read and observe
and
Removing
›
Open the boot lid.
›
Insert the clamps for removing the full wheel trims into opening
›
Remove the cover by pulling the hook in the direction of arrow
›
Unscrew the screws
with the key from the tool kit.
B
›
Grasp the lamp and carefully remove in the direction of arrow
›
Press the latch
on the holder in the direction of the arrow
C
›
Press the safety lug in the direction of arrow
direction of arrow
.
5
Fitting
›
Insert the connector into the light and lock it securely.
›
Tighten the lock in the opposite direction to the arrow
›
Insert the lamp with pins
D
» Fig. 276
›
Carefully push the cover in
»
on page 231 first.
2
3
and pull out the holder in the
4
.
3
into the recesses
E
in the body.
.
›
Screw the lamp into place and install the cover. The cover must engage se-
curely.
›
Close the boot lid.
CAUTION
When installing the light, ensure that the cable bundle does not become
■
pinched between the body and the lamp – risk of damage to the electrical in-
stallation and risk of water ingress.
If you are not sure whether the cable bundle has become pinched, we rec-
■
ommend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in the rear lamp - Option 1 (with LED parking light)
Fig. 277 Outer part of the lamp/holder with bulbs
Read and observe
» Fig.
276.
A
.
1
›
Unlock the bulb holder using the marked area with arrows
move the bulb holder from the light.
.
›
Turn the respective light bulb counter-clockwise to the stop and remove it
.
from the bulb holder.
›
Insert a new bulb into the holder and turn in a clockwise direction to the
stop.
›
Insert the bulb holder into the light
and
on page 231 first.
»
. The holder must engage securely.
Fuses and light bulbs
» Fig. 277
and re-
235