Table of Contents
Advertisement
Note
During control, speed can be increased by pressing the accelerator pedal. Re-
■
leasing the accelerator pedal will cause the speed to drop again to the set
speed.
By pressing the button
» Fig. 205
D
■
celled and the Speed Limiter is activated.
Speed limiter
Introduction
The speed limiter limits the maximum driving speed to the set speed limit.
The speed limit can only be exceeded by depressing the accelerator pedal fully.
The condition in which the speed limiter prevents a set speed limit from being
exceeded is referred to hereinafter as Regulation.
WARNING
The general information relating to the use of assistance systems must be
observed
» page 171,
in section Introduction.
Operation
Fig. 206 MAXI DOT display (monochromatic): Examples of speed limiter
status displays
180
Driving
during the control procedure this is can-
Fig. 207 Segment display: Examples of speed limiter status displays
Read and observe
on page 180 first.
Speed limiter status displays
» Fig.
Speed limit set, but regulation is inactive.
Control is active.
No speed limit set.
System fault - seek assistance from a specialist garage immediately.
Basic requirements for start of control
The speed limiter is activated.
The current speed is higher than 30 km/h.
206,
» Fig. 207
Advertisement
Table of Contents
