Use The Towing Device - Skoda RAPID 2017 Owner's Manual

Table of Contents

Advertisement

Note
We recommend that you use accessories from ŠKODA Original Accessories.

Use the towing device

Trailer (accessory) connect and disconnect
Connecting / disconnecting
Install the tow bar and the remove the protective cap
page 186.
Place the trailer (the accessory) onto the ball head.
Grasp the 13-pin socket at the handle
the arrow
» Fig.
225.
Plug the trailer (accessory) connector into the 13-pin socket. (If the trailer /
accessories have a 7-pin connector, use a corresponding reduction piece
from the ŠKODA Original Accessories).
Suspend the breakaway cable of the trailer at the safety eyelet
breakaway cable must sag in all trailer settings in view of the vehicle).
Uncoupling takes place in reverse order.
Exterior mirrors
You should have additional exterior mirrors fitted if you are not able to see the
traffic behind the trailer using the standard rear-view mirrors.
Headlights
The front of the vehicle may lift up when a trailer (accessory) is being towed
and the headlights may dazzle other road users. Set the range of the headlights
» page
62.
190
Driving
Fig. 225
Swivel out the 13-pin power
socket, safety eyelet
» Fig. 214
on
3
and swing out in the direction of
A
(the
B
Power supply of the trailer / accessory power system
In the electrical connection between the vehicle and trailer (accessory), the
trailer (accessories) is supplied with power from the vehicle (with ignition
switched on and off).
With the engine switched off, the vehicle battery is discharged by the connec-
ted consumers.
At low charge state of the vehicle battery, the power supply to the trailer (ac-
cessories) is interrupted.
WARNING
An improperly connected electrical installation of the trailer (accessories)
may result in an accident or serious injury from electrical shock.
Do not make any adjustments to the electrical installation of the vehicle
and the trailer (accessories) - risk of an accident or serious injury from elec-
trical shock.
After the electrical connection between the vehicle and trailer (accesso-
ry) the trailer / accessory lights should be checked for function.
Never use the securing eye to tow - risk of accident!
CAUTION
An improperly connected electrical installation of the trailer (accessories) can
lead to the inoperability of the vehicle electronics.
The total power consumption of all the connected consumers to the trailer
power supply must not exceed 350 watts, otherwise there is a risk of damage
to the electrical system of the vehicle.
Loading a trailer
Correct the tyre inflation pressure on the vehicle for "full
Distribution of the cargo
Distribute the cargo in the trailer in such a way that heavy items are located as
close to the trailer axle as possible. Secure the load from slipping.
The distribution of the weight is very poor if your vehicle is unladen and the
trailer is laden. Drive with particular caution if you cannot avoid driving with
this combination.
load"» page
211.

Advertisement

Table of Contents
loading

Table of Contents