Lights And Visibility; Light - Skoda SUPERB Owner's Manual

Lights and visibility

Light


Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
For the basic position of the light switch, use position .
Note
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
Operating the lights
To switch on/off the lights, turn the
ing positions (equipment-dependent).
Switching off lights (except daytime running lights)

Switching the light on/off automatically

Switching on the parking lights or parking lights on both sides

Switching on the low beam

Headlight range control of the Halogen headlights
The headlight range can be set in Infotainment in the menu
The range of the halogen headlights can be set on the screen, in accordance
with the vehicle load, to the following basic settings.
Front seats occupied, boot empty

All seats occupied, boot empty

68
Using the system
Fig. 60
Light switch
» Fig. 60 switch to one of the follow-
A
» page 69
» page 71
/  →  → Light.

All seats occupied, boot loaded

Driver seat occupied, boot loaded

In the event of another vehicle loading condition, the setting for positions . . 
can be used.
The Xenon headlights feature no manual headlight range control. After
switching on the ignition, adjust these automatically to the load and driving
condition of the vehicle.
WARNING
Always adjust the headlight range control to comply with the following
conditions and prevent accidents.
The vehicle does not dazzle other road users, especially oncoming vehi-
■
cles.
The beam range is sufficient for safe driving.
■
Note
If, with a dipped beam, the ignition is turned off, then the dipped beam will
■
automatically switch off and the parking lights will come on. Does not apply to
the position , as long as the conditions are met for the COMING HOME
function . The parking lights are switched off when the ignition key is removed
(for vehicles with the KESSY system, after opening the driver's door).
If there is a fault in the light switch, the low beam comes on automatically.
■
Daytime running lights
The daytime running lights illuminate the area in front of and to the rear of the
vehicle (only applicable for some countries).
The lights are switched on automatically if the following conditions are
met.
The light switch is in the position  or .

The ignition is switched on.

WARNING
Always switch on the low beam when visibility is poor.
Note
The light can operate automatically under certain circumstances, even if the
light switch is in position .