WARNING
Instructions before beginning work in the engine compartment
Stop the engine and remove the ignition key, on vehicles with the KESSY
■
system, open the driver's door.
Firmly apply the handbrake.
■
For vehicles with manual transmission the lever into the neutral position.
■
For vehicles with automatic transmission, place the selector lever in the P
position.
Allow the engine to cool.
■
Never open the bonnet if you can see steam or coolant flowing out of the
■
engine compartment – risk of scalding! Wait until the steam or coolant has
stopped escaping.
WARNING
Information for working in the engine compartment
Keep everyone away from the engine compartment.
■
Do not touch any hot engine parts – risk of burns!
■
Never touch the radiator fan. The radiator fan may still turn suddenly
■
about 10 minutes after switching off the ignition!
Do not smoke in the vicinity of the engine and avoid the use of open
■
flames or sparks.
Do not leave any items (e.g. cloths or tools) in the engine compartment.
■
This presents a fire hazard and the risk of engine damage.
Read and observe the information and warning instructions on the fluid
■
containers.
WARNING
Information for working in the engine compartment with the engine run-
ning
If it is necessary to work on the engine with the engine running, beware
■
of rotating engine parts and electrical plants - they can be fatal!
Never touch the electric wiring on the ignition system.
■
Avoid short circuits in the electrical system, particularly on the vehicle's
■
battery.
CAUTION
Only refill using fluids with the proper specification - risk of damage to the ve-
hicle!
Note
Fluids with the proper specifications can be purchased from the ŠKODA
■
Original Accessories or from the ŠKODA Genuine Parts ranges.
We recommend you have the operating fluids replaced by a specialist ga-
■
rage.
Opening and closing the bonnet
Fig. 230 Opening the bonnet
Read and observe
and
Open flap
›
Ensure that the windscreen wipers are not raised away from the windscreen
- risk of damage to the bonnet.
›
Open the front door and pull the release lever below the dash panel in the
direction of arrow
» Fig.
230.
1
›
Press the release lever in the direction of arrow
locked.
›
Raise the bonnet in the direction of the arrow
›
Remove the lid prop in the direction of arrow
on page 202 first.
and the bonnet will be un-
2
.
3
from the holder.
4
Inspecting and replenishing
203