Attaching the rear headrests
Fig. 100 Inserting: adapter/holder
Fig. 101 Removing: holder/adapter
Read and observe
on page 82 first.
›
To insert, attach the opened adapter to the guide rods of the front headrest
and clip in the direction of arrow
›
Clip the holder in the direction of arrow
›
To remove, pull on the securing tab
holder out of the adapter in the direction of arrow
›
Press the adapter and remove in the direction of the arrow
guide rods of the headrest.
WARNING
Be careful with the adapter – otherwise there is a risk of finger injury.
» Fig. 100
»
.
1
into the adapter.
2
in direction of arrow
and take the
A
3
» Fig.
101.
4
from the
5
Handle holder
Fig. 102 Tilt and rotate holder
Read and observe
on page 82 first.
The holder may be tilted by 30° in the direction of the arrow
360° in the direction of arrow
2
›
To adjust the holder size, pull out the securing tab
row
and push the part
in the direction of arrow
3
B
tion
» Fig.
103.
Note
If there is no external device in the holder, then we recommend that the part
is moved down fully. Otherwise, irritating noises may occur at certain
B
speeds.
Fig. 103
Adjust holder size
and turned by
1
» Fig.
102.
in the direction of ar-
A
to the desired posi-
4
Useful features
83