Table of Contents
Advertisement
Activating operation of the sunshade
Read and observe
and
If the operation of sunshade is deactivated (e.g. after disconnecting and con-
necting the battery), then the operation will have to be activated.
›
Turn on the ignition and set the switch to position
›
Press the button and hold down.
The sunshade opens and closes again after around 10 seconds.
›
Release the button.
on page 69 first.
» Fig. 61
on page 70.
Lights and visibility
Light
Introduction
Unless otherwise stated, the lights only work when the ignition is switched on.
For the basic position of the light switch, use position .
Note
The headlights may mist up temporarily. When the light is switched on, the
light-emitting surface demists after a short period of time.
Operating the lights
To switch on/off the lights, turn the
positions (equipment-dependent).
Switch off lights (except daytime running lights)
Switching the light on/off automatically
Switching on the parking lights or parking lights on both sides
Switch on the low beam
Headlight range control of the Halogen headlights
The headlight range can be set in Infotainment in the menu
The range of the halogen headlights can be set on the screen, in accordance
with the vehicle load, to the following basic settings.
Front seats occupied, boot empty
All seats occupied, boot empty
Fig. 62
Light switch
» Fig. 62
switch to one of the following
A
» page 73
» page 76
/ → → Light.
Lights and visibility
71
Advertisement
Table of Contents
