Table of Contents
Advertisement
The following function surfaces are displayed
2D - Two-dimensional map display
3D - Three-dimensional map display
Display of the route from the current vehicle location to the destination
Display of the position of the destination or the next stopover on the map
(depending on the setting for menu item → Advanced settings → Status line:)
Automatic map display in day or night mode (depending on the currently
A
active vehicle lighting)
Daytime map display
B
Night-time map display
C
Switch the split screen display on/off
D
Switch the display of selected POI categories on/off
E
destination via the map coordinates
If the map scale of the 2D or 3D display is greater than 10 km (5 miles), then
the map is automatically displayed as 2D and aligned in the direction of north.
If the scale is increased beyond this value, then the map is switched back to
the original representation.
Map scale
Fig. 173 Function surfaces for changing the map scale
It is possible to change the map scale manually or to activate the automatic
scale change.
›
Tap the function surface
» Fig.
A
In area
» Fig.
173, function surfaces for changing the map scale are dis-
B
played.
152
Infotainment
» Fig.
172.
» page 144
» page
147, Entering a
173.
Types of manual scale change
Touch the screen with two fingers and pull them apart or close them togeth-
▶
er.
▶
Press the control knob .
Activating automatic scale change
If the automatic scale is active, the map scale will change automatically de-
pending on the type of roads travelled (motorway - smaller map scale / town -
larger map scale) and the manoeuvre to be carried out.
To activate the automatic scale change, go to the main Navigation menu and
▶
tap on function surface → .
Tap the function surface is highlighted in green.
The automatic scale is only active as long as the map is centred on the vehicle
position (the function surface or is hidden).
To deactivate the automatic scale change, go to the main Navigation menu
▶
and tap on function surface → .
The function surface is highlighted in white.
The function is also deactivated when the map is moved or the map scale is
changed manually.
Map view in reduced scale
In the main Navigation menu, tap on function surface
▶
The map scale is reduced for a few seconds and then restored.
Changing map orientation
You can change the map orientation under the following conditions.
→ .
A
Fig. 174
Changing the map orientation
Advertisement
Table of Contents
