Table of Contents
Advertisement
Description of operation
Read and observe
on page 180 first.
Overview of the control elements of the speed limiter
Activate CCS (required condition for the subsequent activation of
A
the speed limiter)
To activate the speed limiter, the switch must be adjusted to posi-
tion , then press
D
Interrupt control (sprung position)
Deactivate speed limiter (set limit delete)
Take control again
B
a)
km/h), hold (in increments of 10 km/h)
Start regulation / reduce speed - press (in increments of 1 km/h),
C
hold (in increments of 10 km/h)
Switching between CCS and speed limiter
D
a)
If no speed limit is set, the current speed is set as the speed limit.
After starting the system, the current speed is set as the speed limit, the warn-
ing light
lights up in the instrument cluster.
Exceeding the speed limit during the regulation
If, during the control, it is necessary to exceed the speed limit (e.g. to over-
take), the accelerator pedal must be pressed fully.
When exceeding the speed limit (e.g. driving down a hill), an acoustic signal
sounds and the warning light
flashes in the instrument cluster.
The regulation is resumed once the speed has fallen below the set limit.
Fig. 208
Operating elements of the
speed limiter
» Fig. 208
to operate.
/ increase speed - press (in increments of 1
Note
By pressing the button
during the regulation this is cancelled and the CCS is
D
activated.
Front Assist
Introduction
The Front Assist (hereinafter referred to as system) warns you of the danger
of a collision with a vehicle or another obstacle in front of the vehicle, and tries
to avoid a collision or mitigate its consequences by automatically applying the
brakes where necessary.
The area in front of the vehicle is monitored by a radar
WARNING
The general information relating to the use of assistance systems must be
■
observed
» page 171,
in section Introduction.
The system does not respond to crossing or oncoming objects.
■
CAUTION
In case of failure of more than one brake light on the vehicle or on the electri-
cally connected trailer, the system becomes unavailable.
Settings in Infotainment
Read and observe
and
›
In the Infotainment, in menu
tance.
Front Assist (ambient traffic monitor. sys.) – Set the assist system for dis-
■
tance monitoring to the vehicles ahead
Active – Activate/deactivate the assis system
■
Advance warning (Version 1) – Activate/deactivate advance warning
■
Advance warning (Version 2) – Activate/deactivate and set the distance level
■
at which a warning occurs
Display distance warning – Activate/deactivate distance warnings
■
sensor» page
on page 181 first.
, tap in the function surface → Driver assis-
Assist systems
171.
181
Advertisement
Table of Contents
