Table of Contents
Advertisement
Note
The air inlet in front of the windscreen must be free of e.g. ice, snow or
■
leaves to ensure that the heating and cooling system operates properly.
After switching on the cooling Condensation from the evaporator of the air
■
conditioning may drip down and form a puddle below the vehicle. This is not a
leak!
If the coolant temperature is too high, the cooling system is switched off to
■
ensure that the engine cools down.
Heating and manual air conditioning
Fig. 114 Controls of the heating / air conditioning
Read and observe
on page 88 first.
Individual functions can be adjusted or switched on by turning the dial or
pressing the corresponding button
warning light illuminates in the button.
Setting temperature
A
Reduce the temperature /
▶
Set the blower speed (Level 0: Fan off, stage 4: highest speed)
B
Setting the direction of the air flow
C
Air flow to the windows
Air flow to the upper body
Air flow to the footwell
Air flow to the windows and the footwell
Switching recirculation on/off
Switch the cooling system on/off
» Fig.
114. When the function is activated, a
Increase the temperature
» page 91
» page 90
Information on the cooling system
After pressing the buttonthe indicator light on the button lights up, even if
not all the conditions for the cooling system have been met. The cooling sys-
tem starts to work as soon as the following conditions have been met
» page
88.
Note
To ensure adequate thermal comfort, during operation of the manual air condi-
tioning there could be an increase in the engine idle speed in some circumstan-
ces.
Climatronic (automatic air conditioning)
Fig. 115 Controls the Climatronic
Read and observe
on page 88 first.
Individual functions can be adjusted or switched on by turning the dial or
pressing the corresponding button
Setting temperature
1
▶
Reduce the temperature /
Selected temperature
2
Degrees Celsius or Fahrenheit
3
Automatic operation of the air conditioning system is switched on
4
Intensive air flow to the windscreen switched on
5
Direction of air flow
6
Recirculated air mode activated
7
Cooling system activated
8
Set blower speed
9
» Fig.
115.
Increase the temperature
Heating and ventilation
89
Advertisement
Table of Contents
