Table of Contents
Advertisement
Guidelines and function surfaces
Fig. 202 Infotainment screen: orientation lines/function surfaces
Read and observe
and
On the screen, orientation lines are shown along with the monitored area be-
hind the vehicle.
Distance of the orientation lines behind the vehicle
The distance is about 40 cm (safety distance limit).
A
The distance is about 100 cm.
B
The distance is about 200 cm.
C
The distance may vary slightly depending on the load of the vehicle and the
road inclination.
The distance between the side lines corresponds approximately to the vehicle
width including mirrors.
Function surfaces
» Fig. 202
Depending on the Infotainment type: Switches off the display of the
area behind the vehicle
Screen settings – brightness, contrast, colour
Switching on/off audible parking signals
Switching on/off the reduced park assistance display
Change to park assistance display
CAUTION
The objects shown on the screen can be closer or even further away than they
appear. This is especially the case in the following situations.
Protruding objects, such as the rear of a truck and the like.
■
178
Driving
on page 177 first.
» Fig. 202
When driving from a horizontal surface into a slope or a depression.
■
When driving from a slope or a depression onto a horizontal surface.
■
Cruise Control System
Introduction
The Cruise Control System (CCS) maintains a set speed without you having to
actuate the accelerator pedal. The state where the CCS maintains the speed is
referred to hereinafter as the control.
WARNING
The general information relating to the use of assistance systems must be
■
observed
» page 171,
in section Introduction.
After pressing the clutch pedal, no interrupted control occurs! For exam-
■
ple, if a different gear is engaged and the clutch pedal is released, control is
continued.
Operation
Fig. 203 MAXI DOT display (monochromatic): Examples of CCS status
displays
Advertisement
Table of Contents
