1.3.2
How to create a program
This section shows how to create the following sample program.
The program has been created. In the next procedure, convert the program.
1.4
Converting a Program
Operation of a program is defined after converting its ladder.
[Compile]
The program has been converted. In the next procedure, write the program to a CPU module.
● To use a label, the program must be compiled.
GX Works2 Version1 Operating Manual (Common)
● After modifying a program, it must be compiled.
24
↓
↓
[Build]
When X10 is turned on, Y20 turns on.
1.
To enter X10, type X10 at the original cursor
position and select the contact shown in the left
figure.
2.
To enter Y20, type Y20 and select the coil shown in
the left figure.