Mitsubishi L02CPU User Manual page 298

Item
*2
Latch (1) Start/Latch (1) End
*2
Latch (2) Start/End
Local Device Start/End
Device Points
File Register
Extended
Latch (1) Start/Latch (1)
Setting
End
(latch clear enabled)
Latch (2) Start/End
(latch clear disabled)
Indexing
Setting for ZR 32Bit Indexing
Device
*1 When changing the device points, new setting must not exceed the refresh ranges of network modules or the auto
refresh ranges of intelligent function modules. If a new device point setting exceeds the corresponding device range, the
data may be written to another device or an error may occur.
*2 When latching a device, consider the increase in the scan time because the scan time increases.
( Page 304, Appendix 2.1)
*3 The points for the step relay (S) can be changed to 0.
296
Parameter
Description
No.
Set a latch range (start and
end device numbers) to be
2001
H
cleared by remote latch clear
operation.
Set a latch range (start and
end device numbers) not to
2002
H
be cleared by remote latch
clear operation.
Set a range (start and end
2003
device numbers) to be used
H
for a local device.
Set points for the file register
(ZR), extended data register
2000
H
(D), and extended link
register (W).
Set a latch range (start and
end device numbers) to be
2004
H
cleared by remote latch clear
operation.
Set a latch range (start and
end device numbers) not to
2005
H
be cleared by remote latch
clear operation.
Select Z or ZZ device for 32-
2000
H
bit indexing.
Setting range
Setting is available for only
one range for each of B, F,
V, T, ST, C, D, and W
devices.
Setting is available for only
one range for each of L, B,
F, V, T, ST, C, D, and W
devices.
Setting is available for only
one range for each of M, V,
T, ST, C, D, and Z devices.
• Points of the file register
(ZR)
• Assign part of the file
register points to the
extended data register
and extended link
register.
Each latch range for the file
register (ZR), extended data
register (D), and extended
link register (W).
Each latch range for the file
register (ZR), extended data
register (D), and extended
link register (W).
Z0 to Z18 (when using
Use Z
device Z)
Default Reference
⎯
Page 83,
⎯
Section 3.4
⎯
⎯
Page 83,
Section 3.4,
Page 255,
Section 5.5,
⎯
Page 259,
Section 5.6,
Page 264,
Section 5.7
⎯