Mitsubishi L02CPU User Manual page 63

(2) Initial scan time
Initial scan time is the execution time of initial execution type program. When multiple programs are executed, the
initial scan time will be the time required for completing all the initial execution type program execution.
Since the CPU module stores the initial scan time into the special register (SD522 and SD523), the initial scan
time can be checked by monitoring SD522 and SD523. (Accuracy: ±0.1ms)
SD522
If the stored values in SD522 and SD523 are 3 and 400 respectively, the initial scan time is 3.4ms
Ex. Ex.
Even if the WDT instruction (instruction that resets the watchdog timer) is executed in the program, the
measurement of the initial scan time continues.
When an interrupt program or fixed scan execution type program is executed before completion of the initial execution type
program execution, the execution time of the executed program will be added to the initial scan time. When an interrupt
program of fixed scan execution type program is executed before completion of the initial execution type program execution,
the execution time of the executed program will be added to the initial scan time.
(3) Initial execution monitoring time
Initial execution monitoring time is a timer for monitoring initial scan time.
Project window
Set initial execution
monitoring time.
The setting range is 10 to 2000ms (in increments of 10ms). No default value is set.
(4) Precautions on programming
Initial execution type programs do not support the instructions that require several scans (instructions with
completion device).
SEND, RECV and similar instructions
Ex. Ex.
SD523
Stores the initial scan time of 1ms or less (unit:
Stores the initial scan time. (in increments of 1ms)
[Parameter] [PLC Parameter]
CHAPTER 2 APPLICATION OF PROGRAMMING
s)
[PLC RAS]
2
61