Mitsubishi L02CPU User Manual page 124

(3) How to check the execution status
• By displaying the "Check/Disable Executional Conditioned Device Test Registration" dialog box
• By the flash of the MODE LED in green
• By the on status of the first bit in SD840 (Debug function usage)
When checking by the MODE LED or SD840, remind that they are also used to check the execution status of the external
input/output forced on/off function. (
(4) Registering executional conditioned device test settings
(a) Operation method
1.
Open a dialog box to edit the program and select the step number to register.
2.
The setting can be set by "Executional Conditioned Device Test" dialog box.
[Debug]
Test...]
Item
Device/Label
For bit device
Data Type
For word device
Program Name
Execute
Step No.
Condition
Execution Timing
Multiple executional conditioned device test settings can be registered for one step number.
However, if more than one executional conditioned device test settings are registered with the same device
name and the same execution timing for one step number, the set data are overwritten. (More than one setting
with the same device name can be registered for one step, if the execution timing differs.)
122
Page 269, Section 5.8)
[Executional Conditioned Device Test]
Target device or label is displayed. (Data entry is also available)
Forced on/off operation is executed.
Enter a value. (For a signed value, specify decimal or hexadecimal.)
Select the name of the program that is registered in the CPU module.
Specify the step number (step number from 0 to END instruction) that exists in the program. (Specification of
a start step of the instruction.)
Select either "Before Executing Instruction" or "After Executing Instruction".
[Register Executional Conditioned Device
Description
Devices that can register executional
conditioned device test for the start step
of the + instruction