FX
-20SSC-H Positioning Block User's Manual
3U
7.5.3
Changing the target address
This function is used to change the target address in positioning control to a new specified address.
1. To make target address change valid
Specify the following settings.
Setting item
Change command in operation disabled
Target position change value (address)
Target position change value (speed)
Target position change command in
positioning operation
Note
To leave the operation speed unchanged, set the target position change value (speed) to the same speed as
the current operation speed.
2. Applicable positioning operations
• Operations applicable to the target address
change function
- 1-speed positioning operation
- Interrupt 1-speed constant quantity feed
- 2-speed positioning operation
- Interrupt 2-speed constant quantity feed
- Interrupt stop
3. Operation
1) When changing both the address and speed
Target position change command
(speed) in positioning operation
Changing target address
]
2) When the direction of operation changes
Target position change command
(speed) in positioning operation
48
OFF
Set the new target address.
Set the new operation speed.
ON at target address change
Speed
Operation speed
OFF
OFF
Speed
OFF
OFF
Changing target address
7.5 Changing During Operation (Operation Speed, Target Address)
Description
• Operations inapplicable to the target address
change function
- Mechanical zero return
- Manual pulse generator operation
- JOG operation
- Variable speed operation
- Multi-speed operation
- Linear interpolation
- Linear interpolation (interrupt stop)
- Circular interpolation
New operation speed
Target address
ON
ON
Target address
New target
address
Turnover
ON
ON
7 Before Starting Positioning Operation
New target address
Time
Time