Torque Limit [Bfm #14038, Bfm #14238]; Zero Return Torque Limit [Bfm #14040, Bfm #14240]; External Input Selection [Bfm #14044, Bfm #14244] - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U

11.1.18 Torque limit [BFM #14038, BFM #14238]

This parameter sets the torque limit for the servo motor and magnifies the servo motor torque in the range
from 0.1 to 1000.0%. For a target move with a torque limit, refer to the section shown below.
BFM Number
X-axis Y-axis
BFM #14038 BFM #14238

11.1.19 Zero return torque limit [BFM #14040, BFM #14240]

This parameter sets the torque limit for the mechanical zero return operation (creep speed) and magnifies the
servo motor torque during the zero return operation (creep speed) in the range from 0.1 to 1000.0%.
BFM Number
X-axis Y-axis
BFM #14040 BFM #14240

11.1.20 External input selection [BFM #14044, BFM #14244]

BFM Number
X-axis Y-axis
BFM #14044 BFM #14244
→ For details on the torque limit, refer to Subsection 7.6.3
Setting range: 1 to 10000 (× 0.1%)
→ For details on the torque limit, refer to Subsection 7.6.3
Setting range: 1 to 10000 (× 0.1%)
Bit
Number
Sets the FLS, RLS signals from the servo amplifier to be used/not used
→For instructions on how to use forward/reverse rotation limit,
1: Use
b0
Use forward/reverse rotation limits from the servo amplifier and those from
the PLC.
0: Not use
Use only forward/reverse rotation limits from the PLC.
Sets the DOG signals from the servo amplifier to be used/not used
→For details on the mechanical zero return, refer to Section 8.1
1: Use
Use DOG signals from the servo amplifier.
b1 0: Not use
Use DOG signals from the 20SSC-H.
The "b12" in command parameter1 sets the 20SSC-H DOG signal.
b2 to b7 Not available
Sets the FLS/RLS signal logic of the servo motor
b8 1: NC-contact (servo amplifier)
0: NO-contact (servo amplifier)
Sets the DOG signal logic of the servo motor
b9 1: NC-contact (servo amplifier)
0: NO-contact (servo amplifier)
b10 to b15 Not available
11 Buffer Memory (Parameters & Monitored Data)
Description
Description
Description
refer to Section 7.3
→For details on the operation parameters 1,
refer to Subsection 11.1.1
11.1 Positioning Parameters
Default
K3000
Default
K3000
Default
H0100
111
11
12
13
A