Control Command Enable/Disable [Bfm #522]; Control Command [Bfm #523] - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U

11.4.14 Control command enable/disable [BFM #522]

This data item enables or disables control commands.
Once the model code is stored, control commands are enabled.
BFM Number
X-axis Y-axis
BFM #522
Note
Write the model code (K5220) to the "control command enable/disable" before executing control commands.
After control commands are executed, "0" is automatically stored in the "control command enable/disable."

11.4.15 Control command [BFM #523]

This data item sets data to the buffer memory/the flash memory, or initializes the data.
BFM Number
Bit
Number
X-axis Y-axis
b0
b1
b2
b3
b4
b5
b6
b7
BFM #523
b8
b9
b10
b11
b12
b13
b14
b15
*1. Timing of the detection
1) Level detection: activated when the bit is set or cleared.
2) Edge detection: activated at off-to-on transition.
Before executing control commands:
Write the model code (K5220) to the "control command enable/disable" before executing control commands.
After control commands are executed, "0" is automatically stored in the "control command enable/disable."
Model code (K5220)
Values other than the model code :disables control commands
Setting Item
Writes X-axis positioning parameters (BFM #14000 to
X-axis
Positioning
BFM #14199) into the flash memory.
parameters save
Writes Y-axis positioning parameters (BFM #14200 to
command
Y-axis
BFM #14399) into the flash memory.
Writes X-axis table information (BFM #1000 to BFM
X-axis
#3999) into the flash memory.
Table information Writes Y-axis table information (BFM #4000 to BFM
Y-axis
save command #6999) into the flash memory.
XY- Writes XY-axes table information (BFM #7000 to BFM
axes #12999) into the flash memory.
Writes X-axis servo parameters (BFM #15000 to BFM
X-axis
#15199) into the flash memory.
Servo parameters
save command
Writes Y-axis servo parameters (BFM #15200 to BFM
Y-axis
#15399) into the flash memory.
Not available
Resets X-axis positioning parameters (BFM #14000 to
Positioning
X-axis
BFM #14199) to their factory default.
parameters
initialization
Resets Y-axis positioning parameters (BFM #14200 to
Y-axis
command
BFM #14399) to their factory default.
Resets X-axis table information (BFM #1000 to BFM
X-axis
#3999) to their factory default.
Table information
Resets Y-axis table information (BFM #4000 to BFM
initialization Y-axis
#6999) to their factory default.
command
XY- Resets XY-axes table information (BFM #7000 to BFM
axes #12999) to their factory default.
Resets X-axis servo parameters (BFM #15000 to BFM
X-axis
Servo parameters
#15199) to their factory default.
initialization
Resets Y-axis servo parameters (BFM #15200 to BFM
command
Y-axis
#15399) to their factory default.
Not available
11 Buffer Memory (Parameters & Monitored Data)
Description
:enables control commands
Description
-
-
11.4 Control Data
11
12
Default
K0
13
*1
Default
A
Detection
Edge
-
H0000
Edge
-
133