Intel iAPX 86 User Manual page 204

• 'fI,
C
APPENDIX I
ADDITIONAL INFORMATION
__ F_O_R_I_N_T_E_L._LE_C_® __ S_E_R_IE_S __ III __ U_S_ER_S_
n
,
Change 1
Environmental Considerations
The iAPX 86,88 Family utilities run on and can be used to produce code executable
on the Intellec Series III Microcomputer Development System. Resulting code is also
compatible with the ICE-86 Emulator and DEBUG-86.
The following conventions of the Series III operating system (ISIS-II) are
encountered in running the utilities:
.. The utilities must be executed when the Series III is in the 8086 mode. This
operating mode is activated by entering the RUN command, either in conjunc-
tion with a utility program invocation or by itself (to enter the "interactive"
8086 mode):
>
>
RUN :F1 :LOC86 :F3:MYPROG.LN
• The :Fn: portion of the pathname is the Series III directory-name. In this
configuration, the directory-name is the equivalent of a device name, the device
on which the filename is located. If the file is located on the system disk (:FO:),
the directory-·name may be omitted from the pathname.
• Continuation lines are necessary when. a command or invocation will not fit on
one line. The following example illustrates the line-end conventions to use and
the continuation characters to expect:
> IB,USER.LIB &<cr>
• The LIB86 utility presents an exception to these prompt conventions. Because
this program is interactive, it has its own prompts:
RUN LIB86<cr>
S E R I E S - I I I 8086 LIB R A R I AN
Vx.y
*
*
*
ADD :F1 :SEC.LNK, :F1 :CSC.LN
: F 1 :,. AN,. L N K ,. ,0 ,. RIG. LIB < c r
.-r::.:
C W
- -
The following table defines compatible software version combinations.
ISIS-II
ISIS-III(O)
V4.0 V4.1 V4.2
V1.0 or later
RUN
-
V1.0 V1.0 V1.3
V1.2 V1.3
V1.1
V1.1
or later or later
V1.2
LlNK86
-
V1.0 V1.0 V2.0 V1.0 V2.0
or later or later
CREF86
-
V1.0 or later
LlB86
-
V1.0 or later
LOC86
-
V1.0 or later
OH86
-
V1.0 or later
1-1