Configuring Vlan Routing; Figure 434: Vlan Routing Example Network Diagram - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Configuring VLAN Routing

This section provides an example of how to configure Unified Wired and Wireless Access System software to

support VLAN routing. The configuration of the VLAN router port is similar to that of a physical port. The main

difference is that, after the VLAN has been created, you must use the show ip vlan command to determine the

VLAN's interface ID so that you can use it in the router configuration commands.

The diagram in this section shows a Layer 3 switch configured for port routing. It connects two VLANs, with

two ports participating in one VLAN, and one port in the other. The script shows the commands you would use

to configure Unified Wired and Wireless Access System software to provide the VLAN routing support shown

in the diagram.

Physical Port 0/2

VLAN Router Port 4/1

Layer 2 Switch

Use the following screens to perform the same configuration using the Web Interface:

1. From the LAN > L2 Features > VLAN > VLAN Configuration page, perform the following configuration:

• Create VLANs 10 and 20.

• Include interfaces 0/1 and 0/2 as members of VLAN 10, and set tagging for all interfaces to Tagged.

• Include interface 0/3 as a member of VLAN 20, and set tagging for all interfaces to Tagged.

2. From the LAN > L2 Features > VLAN > Port Configuration page, set the port VLAN ID for interfaces 0/1 and

0/2 to 10 and the port VLAN ID for interface 0/3 to 20.

3. Navigate to the LAN > L3 Features > VLAN Routing Configuration page.

4. Enter 10 in the VLAN ID field, and then click Create.

Layer 3 Switch

Configuring VLAN Routing

Physical Port 0/3

VLAN Router Port 4/2

Layer 2 Switch

Unified Wired and Wireless Access System

Show Quick Links

Table of Contents