Interface Configuration; Figure 120: Igmp Snooping Interface Configuration; Table 104: Igmp Snooping Interface Configuration Fields - D-Link DWL-8600AP User Manual

D-Link UWS User Manual

Interface Configuration

Use the IGMP Snooping Interface Configuration page to configure IGMP snooping settings on specific
interfaces.
To access the IGMP Snooping Interface Configuration page, click LAN > L2 Features> IGMP Snooping >
Interface Configuration in the navigation tree.
Field
Interface
Admin Mode
Group Membership Interval
Max Response Time
Multicast Router Present
Expiration Time
Fast Leave Admin Mode
• If you make any changes on the page, click Submit to apply the new settings to the switch.
D-Link
Oct. 2015

Figure 120: IGMP Snooping Interface Configuration

Table 104: IGMP Snooping Interface Configuration Fields

Description
Select the physical or LAG interfaces to configure.
Select the interface mode for the selected interface for IGMP Snooping for the
switch from the pulldown menu. The default is disable.
Specify the amount of time you want the switch to wait for a report for a
particular group on a particular interface before it deletes that interface from
the group. The valid range is from (2 to 3600) seconds. The default is 260
seconds.
Specify the amount of time you want the switch to wait after sending a query
on an interface because it did not receive a report for a particular group on
that interface. Enter a value greater or equal to 1 and less than the Group
Membership Interval in seconds. The default is 10 seconds. The configured
value must be less than the Group Membership Interval.
Specify the amount of time you want the switch to wait to receive a query on
an interface before removing it from the list of interfaces with multicast
routers attached. Enter a value between 0 and 3600 seconds. The default is 0
seconds. A value of zero indicates an infinite timeout; i.e., no expiration.
Select the Fast Leave mode for the a particular interface from the pulldown
menu. The default is Disable. Enabling Fast Leave mode allows the switch to
immediately remove the Layer 2 LAN interface from its forwarding table entry
upon receiving an IGMP leave message for that multicast group without first
sending out MAC-based general queries to the interface.
Configuring IGMP Snooping
Unified Wired and Wireless Access System
Page 215