Debugging The Ap; Figure 375: Managed Ap Debug; Table 344: Managed Ap Debug - D-Link DWL-8600AP User Manual

Dws-4000 series access points

Hide thumbs Also See for DWL-8600AP:

Table of Contents

D-Link UWS User Manual

Command Buttons

The page includes the following button:

• Refresh—Updates the page with the latest information.

Debugging the AP

You can enable debugging on an AP to allow Telnet access to the access point. Once you Telnet to the AP, you

can issue commands from the CLI to help you troubleshoot.

The fields in

Table 344 on page 587

AP Advanced page.

Table 343: Advanced AP Management (Cont.)

Click the Power link to access the Managed AP Channel/Power Adjust page. From

that page, you can set a new power level for the AP. The manual power change

overrides the power setting configured in the AP profile and is not retained when the

AP reboots or when the AP profile is reapplied.

fields on the new page.

appear when you click the Debug link for a managed AP on the Managed

Shows the MAC address of the access point.

Shows the location of the access point, as configured in the Valid AP database.

Shows the IP address of the AP.

Shows the debug status, which can be one of the following:

• None: Debugging has not been enabled or disabled.

• Set Requested: A request has been made to change the debug status.

• Set Complete: Debugging has been enabled or disabled.

Enter the admin password for the AP (the default is admin).

AP Management

Table 345 on page 589

Unified Wired and Wireless Access System

describes the

Show Quick Links

Table of Contents