Omron e5ck User Manual page 85

Pattern No.
• This parameter can be set only when the controller is reset.
• Displays the execution pattern during program operation, and the set pattern after
the controller is reset.
Function
• This parameter can also be used in the program mode.
0 to number of patterns -1
Setting
F Related description
3.5 Setting Patterns (page 3 14)
F Related parameters
See
All parameters in the program mode
Number of patterns" (expansion mode)
Step No. monitor
• Monitors the current step No. (This parameter is reset to 0" when the controller is
reset.)
Function
0 to Number of steps-1
Monitor
F Related description
4.4 Program Operation (page 4 13)
F Related parameters
See
Hold" Advance" (level 0 mode)
Setting Range
Monitor Range
Conditions of Use
The "number of patterns" parameter must
be set to a value greater than "2".
Unit Default
None 0
Unit
None
Level 0 Mode
5–7