Omron e5ck User Manual page 175

APPENDIX
Mode Parameter Name
Set point upper limit
Set point lower limit
PID / ON/OFF
Operation at power ON
End condition
Number of patterns
Program time unit
Step time/Rate of rise pro-
gramming
Time unit of ramp rate
Expan Expan-
sion i
PV start
Alarm during ramp step en-
able
Run all enable
α
AT calculated gain
Automatic return of display
mode
AT hysteresis
LB detection width
Event input assignment 1
Communication stop bit
Communication data length
Communication parity
Communication baud rate
Option p
Communication unit No.
Transfer output type
Transfer output upper limit
Transfer output lower limit
*9 When temperature input is selected, the range of the sensor selected in the input type" parameter (setup mode) corresponds to the
scaling upper and lower limit value.
*10 Set the transfer output type parameter according to the following table.
Transfer Output Type
SP :Present SP
PV :Process value
O :Manipulated variable (heat)
C-O :Manipulated variable (cool)
D
Default : [SP]
A–8
Setting Range
Set point lower limit +1 to scaling upper limit
Scaling lower limit to Set point upper limit -1
PID / ON/OFF
CON/RST/RUN/MAN
RST/SP
1 to 4
HHMM/MMSS
TIME/PR
M/H
PV/SP
ON/OFF
ON/OFF
0.00 to 1.00
0.1 to 10.0
0 to 99
0.1 to 9.9
0.0 to 999.9
NON/RST/MAN/HOLD/ADV/PTN0 to 1
1/2
7/8
NONE/EVEN/ODD
1.2/2.4/4.8/9.6/19.2
0 to 99
SP/PV/O/C-O
*10
*10
Transfer Output Lower Limit to Transfer Output Upper Limit
-5.0 to 105.0% (standard control), 0.0 to 105.0% (heating and cooling control)
Unit Default Remarks
EU 1300
EU -200
None PID
None CON
None RST
None 1
None HHMM
None OFF
None OFF
None SP
None ON
None OFF
None 0.65
None 1.0
Sec 0
%FS 0.2
%FS 0.2
None NON
bit 2
bit 7
None EVEN
kbps 9.6
None 0
None SP
*10 10
*10 *10
-1999 to 9999
-1999 to 9999
0.0 to 105.0%
Setting
*9
*9