Omron e5ck User Manual page 134

CHAPTER 6 USING THE COMMUNICATIONS FUNCTION
Parameter No.
00 PV monitor
01 Set point
04 MV monitor (heat)
14 Valve opening monitor
02 Alarm value 1
03 Alarm value 2
41 Alarm value 3
19 Proportional band
20 Integral time
21 Derivative time
22 Cooling coefficient
09 Dead band
23 Manual reset value
06 Hysteresis (heat)
43 Hysteresis (cool)
07 Control period (heat)
08 Control period (cool)
46 LBA detection time
47 MV at reset
48 MV at PV error
50 MV upper limit
49 MV lower limit
51 MV change rate limit
56 Input digital filter
25 Alarm 1 hysteresis
26 Alarm 2 hysteresis
52 Alarm 3 hysteresis
53 Input shift upper limit
54 Input shift lower limit
*1 Possible only during reading
*2 During temperature input, the range becomes the range of use of the selected sensor.
*3 During heating and cooling control, the range becomes 0.0 to 105.0.
*4 During heating and cooling control, the range becomes 105.0 to 0.0.
*5 During heating and cooling control, the range becomes 105.0 to 105.0.
6–8
Parameter
*1 *2 Scaling lower limit -10% to scaling upper limit +10%
*1
*1
*1
*5
*5
*3
*4
Data Setting and Monitor Range
Set point lower limit to set point upper limit
-5.0 to 105.0
-10.0 to 110.0
-1999 to 9999
-1999 to 9999
-1999 to 9999
0.1 to 999.9
0 to 3999
0 to 3999
0.01 to 99.99
-19.99 to 99.99
0.0 to 100.0
0.01 to 99.99
0.01 to 99.99
1 to 99
1 to 99
0 to 9999
-5.0 to 105.0
-5.0 to 105.0
MV lower limit +0.1 to 105.0
-5.0 to MV upper limit -0.1
0.0 to 100.0
0 to 9999
0.01 to 99.99
0.01 to 99.99
0.01 to 99.99
-199.9 to 999.9
-199.9 to 999.9
Mode
Level 0 Level 0
*3
Level 0
Program g
Level 1
Level 2