Setup Mode - Omron e5ck User Manual

CHAPTER 5 PARAMETERS

Setup Mode

• The parameters in this mode can be used only when the security" parameter (pro
tect mode) is set to 0" and 1".
• This mode contains the parameters for checking or setting the basic specifications of
the E5CK T controller. These parameters include parameters for specifying the input
type, scaling, output assignments, and direct/reverse operation.
• To select this mode, press the
to the menu display. If you select [
the
• To select parameters in this mode, press the
use the
• The following table shows the parameters supported in this mode and the page where
the parameter is described.
5–28
key for 1 second minimum, the controller enters the setup mode.
or keys.
Symbol Parameter Name
Input type
Scaling upper limit
Scaling lower limit
Decimal point
_C/_F selection
Parameter initialize
Control output 1 assignment
Control output 2 assignment
Auxiliary output 1 assignment
Alarm 1 type
Alarm 1 open in alarm
Alarm 2 type
Alarm 2 open in alarm
Alarm 3 type
Alarm 3 open in alarm
Direct/Reverse operation
key for 1 second minimum. The display changes
] pressing the and
key. To change parameter settings,
Page
keys, and then press
5-29
5-30
5-30
5-30
5-31
5-31
5-32
5-32
5-33
5-34
5-35
5-34
5-35
5-34
5-35
5-35