Omron e5ck User Manual page 44

CHAPTER 3 BASIC OPERATION
JPattern No.
JNumber of steps
JStep SP/Step
time
:
:
: : 0 to 15
3–14
• This parameter cannot be changed during controller operation.
• Set the desired pattern No. Step SP , step time, alarms and other parame
ters that follow this parameter are set for the pattern that is set in this
parameter.
• Set within the range 0 to (number of patterns 1). The number of pat
terns" parameter is factory set to 0".
• Set the number of steps for the pattern that you specified in the pattern
No." parameter.
• Set within the range 1 to 16 (step). Default is 8".
• Set only the number of steps used in the program in order from step 0,
as step 0 SP", step 0 time", step 1 SP", step 1 time" and so forth.
• Set within the range from set point lower limit to set point upper limit
for step SP . Default is 0".
• Set within the range 0.00 to 99.59 (hours:minutes or minutes:seconds).
Default is 0.00".
SP
Step 0 Step 1
Step 0 hour Step 1 hour
A: SP of steps 0 and 3
B: SP of steps 1 and 2
• As shown in the above figure, step 0 is a fixed value, so when ramp opera
tion is started, set the step 0 time" parameter to 0.00" to configure the
program so that ramp operation starts from step 1.
Step 2 Step 3
Step 2 hours Step 3 hours
Time