Switch Ports; Channelizing Interfaces - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide

Switch Ports

Channelizing Interfaces

26
This topic describes:
Switch Ports on page 26
Channelizing Interfaces on page 26
Virtual Chassis and Virtual Chassis Fabric Support on page 27
The QFX5100-96S switch ports, (
SFP transceivers that can run at either 100 Mbps or 1 Gbps speed
SFP+ transceivers at 10 Gbps speed
SFP to SFP direct attach copper (DAC) cables
SFP+ to SFP+ DAC cables
SFP+ to SFP+ active optical cables (AOC)
Ports through support:
96 104
40 Gbps QSFP+ transceivers
Additionally ports and
96
SFP+ transceivers
QSFP+ to QSFP+ direct attach copper (DAC) cables
QSFP+ to SFP+ DAC breakout cables (DACBO)
QSFP+ to QSFP+ active optical cables (AOC)
QSFP+ to SFP+ AOC breakout cables (AOCBO)
CAUTION: Do not place a copper transceiver in an access port directly above
or below another copper transceiver. Internal damage to the access ports
and switch can occur. We recommend either using the top port row
exclusively, or bottom port row exclusively, for copper transceivers.
The port panel of the QFX5100-96S switch supports up to a maximum of 104 logical 10
GbE ports that can be distributed over 96 small form-factor pluggable plus (SFP+) and
8 quad small-form factor pluggable plus (QSFP+) transceivers . Because of an 104 port
restriction, only two of the eight QSFP+ can be channelized. Depending on how you set
the system mode for channelization, the behavior of channelization for the QSFP+
changes. The following system modes are available for the QFX5100-96S switch:
Non-oversubscribed
0 through 95 ) support:
support:
100
Copyright © 2017, Juniper Networks, Inc.