Console Port Connector Pinout Information; Table 35: Console Port Connector Pinout Information - Juniper QFX5100 Hardware Manual

QFX5100 Switch Hardware Guide
Related
Documentation

Console Port Connector Pinout Information

Table 35: Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
6 RxD Input
7 CD Input
8 CTS Input
Related
Documentation
92
NOTE: USB flash drives used with the QFX Series device must support
USB 2.0 or later.
Creating an Emergency Boot Device on page 183
Performing a Recovery Installation Using an Emergency Boot Device on page 185
The console port on a Junier Networks device is an RS-232 serial interface that uses an
RJ-45 connector to connect to a console management device. The default baud rate for
the console port is 9600 baud.
Table 35 on page 92 provides the pinout information for the RJ-45 console connector.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to a device, use a combination of
the RJ-45 to DB-9 female adapter and a USB to DB-9 male adapter. You
must provide the USB to DB-9 male adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Receive data
Data carrier detect
Clear to send
Connecting a Device to a Management Console by Using an RJ-45 Connector on page 120
Configuring the Console Port Type (CLI Procedure)
Copyright © 2017, Juniper Networks, Inc.