Connecting The Switch To The Network; Connecting A Device To A Network For Out-Of-Band Management; Connecting A Device To A Management Console By Using An; Figure 60: Rj-45 Connector On An Ethernet Cable - Juniper QFX5100 Hardware Manual

CHAPTER 11

Connecting the Switch to the Network

Connecting a Device to a Network for Out-of-Band Management

Copyright © 2017, Juniper Networks, Inc.
Connecting a Device to a Network for Out-of-Band Management on page 119
Connecting a Device to a Management Console by Using an RJ-45 Connector on page 120
Connecting QFX Series and EX Series Switches in a QFX Virtual Chassis on page 121
Connecting a QFX5100 Device in a Virtual Chassis Fabric on page 127
You can monitor and manage these devices by using a dedicated management channel.
Each device has a management port to which you can connect an Ethernet cable with
an RJ-45 connector. Use the management port to connect the device to the management
device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
Figure 60 on page 119 shows the RJ-45 connector of the Ethernet cable supplied with the
device.

Figure 60: RJ-45 Connector on an Ethernet Cable

To connect a device to a network for out-of-band management (see
Connect one end of the Ethernet cable to the management port (labeled
1.
ETHERNET ) on the device.
Connect the other end of the Ethernet cable to the management device.
2.
Figure 61 on page 120):
or
MGMT
119