Chassis Lifting Guidelines For A Qfx5100 Device - Juniper QFX5100 Hardware Manual

Related
Documentation

Chassis Lifting Guidelines for a QFX5100 Device

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
Attention Avant de brancher le système sur la source d'alimentation, consulter
les directives d'installation.
Warnung Lesen Sie die Installationsanweisungen, bevor Sie das System an
die Stromquelle anschließen.
Avvertenza Consultare le istruzioni di installazione prima di collegare il sistema
all'alimentatore.
Advarsel Les installasjonsinstruksjonene før systemet kobles til strømkilden.
Aviso Leia as instruções de instalação antes de ligar o sistema à sua fonte
de energia.
¡Atención! Ver las instrucciones de instalación antes de conectar el sistema
a la red de alimentación.
Varning! Läs installationsanvisningarna innan du kopplar systemet till dess
strömförsörjningsenhet.
General Safety Guidelines and Warnings on page 187
Laser and LED Safety Guidelines and Warnings
Grounded Equipment Warning on page 199
The weight of a 1 U fully loaded QFX5100 switch chassis is approximately 30.8 lb (14 kg);
the 2 U product SKU is approximately 32 lbs (14.5 kg). Observe the following guidelines
for lifting and moving a QFX5100 switch:
CAUTION: If you are installing the QFX5100 switch above 60 in. (152.4 cm)
from the floor, either remove the power supplies, fan modules, and any
expansion modules before attempting to install the switch, or ask someone
to assist you during the installation.
Before installing a QFX5100 switch, read the guidelines in
for a QFX5100 Device" on page 63
power, environmental, and clearance requirements.
Before lifting or moving the QFX5100 switch, disconnect all external cables.
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
General Safety Guidelines and Warnings on page 187
Installation Instructions Warning on page 192
Chapter 21: Safety and Compliance Information
"Site Preparation Checklist
to verify that the intended site meets the specified
193