Expansion Modules For Qfx5100 Devices - Juniper QFX5100 Hardware Manual

Table 11: Chassis Status LEDs on a QFX5100 Switch (continued)
Name
MST–Master in a QFX Virtual
Chassis or Routing Engine
Master in a VCF
ID–Identification
Related
Documentation

Expansion Modules for QFX5100 Devices

Copyright © 2017, Juniper Networks, Inc.
Color
Unlit
Green
Green
Unlit
Blue
Management Panel of a QFX5100 Device on page 32
show chassis alarms
request chassis beacon
The QFX5100-24Q and QFX5100-24Q-AA devices have two bays on the port panel for
optional expansion modules. These expansion modules can be hot-inserted or
hot-removed. Expansion modules and transceivers are not shipped with the switch and
must be ordered separately.
The QFX5100-24Q and QFX5100-24Q-AA support these expansion modules up to the
104-port limitation:
Two EX4600-EM-8F, which provides a total of 16 additional 10-Gigabit Ethernet
Enhanced Small Form-Factor Pluggable (SFP+) ports.
Two QFX-EM-4Q, which provides a total of 8 additional 40-Gigabit Quad SFP+
(QSFP+) ports.
One EX4600-EM-8F and one QFX-EM-4Q, which provides 8 additional 10-Gigabit
Ethernet SFP+ and 4 additional 40-Gigabit (QSFP+) ports. This combination requires
the system mode to be configured as Flexi-pic. See Configuring the System Mode.
Chapter 2: Chassis Components and Descriptions
State Description
Off The switch is a linecard member in a QFX
Virtual Chassis.
On steadily The switch is one of the following:
A standalone switch
In the master role in a QFX Virtual
Chassis
Is the routing engine master in a VCF
Blinking The switch is the backup master in a QFX
Virtual Chassis or the backup routing
engine in a VCF.
Off The beacon feature is not enabled on the
switch. This feature is enabled using the
request chassis beacon
Blinking The beacon feature is enabled on the
switch. This feature is enabled using the
request chassis beacon
command.
command.
39