BMW S 1000 RR Rider's Manual page 82

+1 ... +7
: Increase damping
5
through a maximum of seven
levels (harder).
80
-1 ... -7
: Reduce damping
through a maximum of seven
levels (softer).
0
: Factory setting
Press and hold down SET 2
until the value stops flashing.
The value for the riding mode
currently selected is saved.
Performing a zero position
z
alignment
with Dynamic Damping Control
OE
(DDC)
Place the motorcycle on the
side stand or on a suitable aux-
iliary stand.
During the alignment, do not
sit on the motorcycle; remove
pieces of luggage.
Select the submenu (
SETUP DDC-SYS
The
menu is selected.
To calibrate, repeatedly short-
press TRIP 1 or SET 2
until line 4 shows
(Calibration).
Long-press SET 2 until
CALIB
starts to flash.
CALIB
flashes.
The system calibrates to the
zero position.
115).
sub-
To indicate that calibration was
successful, lines 3 and 4 show
CALIB DONE
If CALIB FAIL appears on the
display:
CALIB
Repeat alignment.
CALIB DONE
If
displayed even after the
calibration routine has been
repeated, seek the advice of a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
.
is not