BMW S 1000 RR Rider's Manual page 104

Individualising LAPTIMER
7
102
Activate the default reading
( 111).
The odometer reading (
appears on the display.
Short-press SET 2.
z
The LAPTIMER is called
up and shows in the
factory settings
BESTLAP
4.
If you want to change the con-
tent of lines 3 and 4 in the
LAPTIMER, repeatedly long-
press SET 2 until lines 3 and 4
show the readings you want.
Your chosen LAPTIMER
display layout is accepted and
saved in memory.
LAPTIMER display layout
(
Starting timing
Requirement
The LAPTIMER is called up.
ODO
)
RUN
3 and
Press button 1 to start timing.
The engine has to be running
and the vehicle moving in order
123)
NOTICE
for the headlight-flasher signal to
be detected.
RUN
Timing 2 is running.
Every time you cross the start/
finish line, press button 1 again
to start timing for the next lap.
The data of the preceding lap
are written into memory.
RUN
2 starts again at
00:00:00
.
Timing continues even if you
exit the display mode. In the
other modes, however, timing
of another lap can be started
only by an external signal.
Infrared receiver
with infrared receiver
An infrared signal provides a con-
venient way of operating the
LAPTIMER. In these circum-
stances, note the following:
OA