BMW S 1000 RR Rider's Manual page 51

Alarm signal
A DWA alarm can be triggered
by:
motion sensor
an attempt to use an unauthor-
ised vehicle key to switch on
the ignition.
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash).
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW motorcycle
dealer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
Light signals issued by the
DWA LED:
Flashes 1x: Motion sensor 1
Flashes 2x: Motion sensor 2
Flashes 3x: Ignition switched
on with unauthorised vehicle
key
Flashes 4x: Disconnection of
the DWA anti-theft alarm from
the motorcycle's battery
Flashes 5x: Motion sensor 3
Deactivation
Set the kill switch to operating
position (run).
Switch on the ignition.
Turn indicators flash once.
Confirmation tone sounds once
(if programmed).
Anti-theft alarm (DWA) is deac-
tivated.
DWA adjusting
Switching on ignition (
Repeatedly short-press
SETUP MENU
SET 2 until
4
49
z
40).