with rear-seat cover
7
Remove the tail-hump cover
(
62).
142
Unlock the protective cap or
terminating resistor, as applic-
able, and disconnect it from the
plug.
Connect the optional accessory
or racing accessory, as applic-
able.
NOTICE
Comply with the installation
instructions supplied with the
optional accessory or racing
z
accessory.
NOTICE
Tightening the cable ties has to
be the last step in the process;
this is in order to ensure that
the wiring harness can be posi-
tioned correctly and that there is
no strain on the cable legs with
plugs.
OE
ATTENTION
Dirt and damp penetrating
inside open connectors
Malfunctions
Reinstall the cap or terminating
resistor, as applicable, after re-
moving the plug.
After removing the accessory:
Reinstall the cap or terminating
resistor, as applicable.
Installing side panel (
Install the rear seat (
with rear-seat cover
Install the tail-hump cover
(
62).
186).
63).
OE