Disable A Dhcp Server; Remove A Dhcp Server - NETGEAR WAC510 User Manual

Disable a DHCP Server

The information in this section applies only when the system mode of the access point is Router mode (see
Change the System Mode to Router Mode or AP Mode
access point is enabled and you can also add up to seven additional DHCP servers for WiFi clients only.
You can temporarily disable a DHCP server.
To disable a DHCP server:
1. Open a web browser from a computer that is connected to the same network as the access point or to
the access point directly through an Ethernet cable or WiFi connection.
2. Enter the IP address that is assigned to the access point.
A login window opens.
3. Enter the access point user name and password.
The default user name is admin. The default password is password. The user name and password
are case-sensitive.
The Dashboard page displays.
4. Select Management > Configuration > IP > LAN > DHCP Server Settings.
Note The DHCP Server Settings menu selection is not available when the access point
functions in AP mode.
5. Click the > button to the left the DHCP server.
The settings for the selected DHCP server display.
6. Next to Server (to the left of the VLAN ID menu), select the Disable radio button.
7. Click the Apply button.
Your settings are saved.

Remove a DHCP Server

The information in this section applies only when the system mode of the access point is Router mode (see
Change the System Mode to Router Mode or AP Mode
access point is enabled and you can also add up to seven additional DHCP servers for WiFi clients only.
You can remove a DHCP server that you no longer need.
AC WiFi Business Access Point WAC510
Manage the Local Area Network and IP Settings
on page 84). If it is, the default DHCP server of the
on page 84). If it is, the default DHCP server of the
81