NETGEAR WAC510 User Manual page 8

Table 1. LED descriptions
LED Description
Power LED Off. No power is supplied to the access point.
Solid green. Power is supplied to the access point and the access point is ready.
Solid amber. During startup, the Power LED lights solid amber. If after five minutes the amber
light remains on, a boot error occurred.
Blinking amber temporarily. The access point is upgrading firmware.
Blinking amber continuously. The access point did not receive an IP address from a DHCP
server.
Alternating green and amber. The access point is receiving insufficient PoE power.
Activity LED Off. No link with the network is detected.
Solid green. A link with the network is detected.
Blinking green. Network traffic is detected.
WAN LED Off. No powered-on Ethernet device is connected to the WAN port. If a powered-on Ethernet device
is connected, no Ethernet link is detected.
Solid amber. A 10 or 100 Mbps Ethernet link is detected on the WAN port.
Solid green. A 1000 Mbps Ethernet link is detected on the WAN port.
LAN LED Off. No powered-on Ethernet device is connected to the LAN port. If a powered-on Ethernet device
is connected, no Ethernet link is detected.
Solid amber. A 10 or 100 Mbps Ethernet link is detected on the LAN port.
Solid green. A 1000 Mbps Ethernet link is detected on the LAN port.
2.4G WLAN LED Off. The 2.4 GHz WiFi radio is off.
Solid green. The 2.4 GHz WiFi radio is on.
Solid blue. One or more WLAN clients are connected to the 2.4 GHz WiFi radio.
Blinking blue. Traffic is detected on the 2.4 GHz WiFi radio.
5G WLAN LED Off. The 5 GHz WiFi radio is off.
Solid green. The 5 GHz WiFi radio is on.
Solid blue. One or more WLAN clients are connected to the 5 GHz WiFi radio.
Blinking blue. Traffic is detected on the 5 GHz WiFi radio.
Note For information about troubleshooting with the LEDs, see
on page 115.
AC WiFi Business Access Point WAC510
Hardware Overview of the Access Point
8
Troubleshoot With the LEDs