Disable The Dhcp Server [Router Mode]; Manage The Router Information Protocol Settings [Router Mode] - NETGEAR WAX202 User Manual

WiFi 6 AX1800/AX3200 Dual Band Wireless Access Points, WAX202 and WAX206

Disable the DHCP server [router mode]

If the AP is in router mode, you can use another device on your network as the DHCP
server or specify the network settings of all your computers.
Note: If you disable the DHCP server and do not specify another DHCP server or no
other DHCP server is available on your network, you must set your computer IP addresses
manually so that they can reach the AP.
To disable the DHCP server:
1. Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2. Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 39.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. Clear the Use Router as DHCP Server check box.
6. Click the Apply button.
Your settings are saved.
Manage the Router Information Protocol settings [router
mode]
If the AP is in router mode, Router Information Protocol (RIP) lets the AP exchange
routing information with other routers. By default, RIP is enabled in both directions (in
and out) without a particular RIP version.
To manage the RIP settings:
1. Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2. Enter http://www.routerlogin.net in the address field.
Network Settings 78 User Manual