Factory Settings - NETGEAR WAC510 User Manual

Factory Settings

You can reset the access point to the factory default settings, which are shown in the following table.
For more information about resetting the access point to its factory settings, see
to Its Factory Default Settings
Table 2. WAC510 access point factory default settings
Feature
Access point login
User login URL
User name (case-sensitive)
Login password
(case-sensitive)
General system settings
Operating Mode
DHCP client
Country/region
NTP client
Spanning Tree Protocol
Network integrity check
802.1Q VLAN
Management VLAN
Syslog
Ethernet LLDP
UPnP
WiFi network for initial setup
SSID name
Security
RF channel
AC WiFi Business Access Point WAC510
on page 94.
Default Setting
192.168.0.100
admin, nonconfigurable
password, configurable
AP mode
By default, Router mode is disabled, including NAT and the DHCP server
function.
Enabled so that the access point receives an IP address from a DHCP
server in the network.
United States
Enabled
Disabled
Disabled
Untagged VLAN with VLAN ID 1
VLAN ID 1
Disabled
Enabled
Enabled
SSID for initial setup is NETGEARxxxxxx-SETUP, where xxxxxx is the last
six hexadecimal digits of the access point's MAC address.
WPA2-PSK
WiFi password (network key): sharedsecret
Auto. The available channels depend on the region.
Factory Default Settings and Technical Specifications
122
Return the Access Point