NETGEAR WAC510 User Manual page 20

To connect to the access point using a computer that is connected to the LAN port of the
access point:
1. Record the IP address and subnet mask of your computer so that you can reinstate these IP address
settings later.
2. Temporarily change the IP address on your computer to 192.168.0.210 with 255.255.255.0 as the subnet
mask.
(You can actually use any IP address in the 192.168.0.2–192.168.0.254 range, with the exception of IP
address 192.168.0.100, which is the access point default IP address.)
For more information about changing the IP address on your computer, see the help or documentation
for your computer.
3. Use an Ethernet cable to connect your computer to the LAN port on the access point.
4. On the computer, open a web browser and enter 192.168.0.100 in the address bar.
The Day Zero Easy Setup page displays. This page displays only the very first time that you access the
access point.
5. To let the access point detect if new firmware is available, click the Check for Upgrade button.
To detect new firmware, the access point must already be connected to the Internet. You can also let
the access point detect new firmware later.
If new firmware is available, you can upgrade the access point. You can also upgrade the access point
later.
6. Enter the settings that are described in the following table.
Install the Access Point in Your Network and Access It for Initial Configuration
AC WiFi Business Access Point WAC510
20