NETGEAR WAC510 User Manual page 18

point functions as a DHCP client. If you want to set up the access point with a static (fixed) IP address, see
Connect Over Ethernet Using a Directly Connected Computer
To connect to the access point using a computer that is connected to the same network as
the access point:
1. To determine the IP address that the DHCP server assigned to the access point, access the DHCP
server or use an IP network scanner.
2. On the computer, open a web browser and, in the address bar, enter the IP address that is assigned to
the access point.
The Day Zero Easy Setup page displays. This page displays only the very first time that you access the
access point.
3. To let the access point detect if new firmware is available, click the Check for Upgrade button.
To detect new firmware, the access point must already be connected to the Internet. You can also let
the access point detect new firmware later.
If new firmware is available, you can upgrade the access point. You can also upgrade the access point
later.
4. Enter the settings that are described in the following table.
Setting
Country/Region
Time Zone
Install the Access Point in Your Network and Access It for Initial Configuration
AC WiFi Business Access Point WAC510
Description
From the menu, select the country and region in which the access point is operating.
From the menu, select the time zone for the country and region in which the access
point is operating.
18
on page 19.