Pair A Stride, Speed Or Cadence Sensor With V800 - Polar Electro V800 Owner's Manual

or
1. Go to General Settings > Pair and sync > Pair other device
2. V800 starts searching for your heart rate sensor.
3. Once the heart rate sensor is found, the device
4. Press START,
5. Pairing completed
When using a H7 heart rate sensor, V800 may detect your heart rate via GymLink transmission before
you have paired it. Make sure you have paired your heart rate sensor before starting training. GymLink
transmission is optimized to be used in swimming, therefore your heart rate is shown in gray in other sport
profiles if you haven't paired your heart rate sensor via Bluetooth®.

PAIR A STRIDE, SPEED OR CADENCE SENSOR WITH V800

Before pairing a stride sensor, cadence sensor or speed sensor, make sure they have been correctly installed.
For more information on installing the sensors see their user manuals.
There are two ways to pair a sensor with your V800:
1. Press START in time view to enter pre-training mode.
2. V800 starts searching for your sensor.
Stride sensor: Touch your stride sensor with V800, and wait for it to be found.
l
Cadence sensor: Rotate the crank a few times to activate the sensor. The flashing red light in
l
the sensor indicates that the sensor is activated.
Speed sensor: Rotate the wheel a few times to activate the sensor. The flashing red light in the
l
sensor indicates that the sensor is activated.
3. The device ID Pair Polar RUN/CAD/SPD xxxxxxxx
4. Pairing completed
or
1. Go to General Settings > Pair and sync > Pair other device
2. V800 starts searching for your sensor.
3. Once the sensor is found, the device ID
4. Press START,
5. Pairing completed
For more information on pairing specific sensors, "Sensors" on page 89
Pairing is displayed.
is displayed when you are done.
is shown when you are done.
Pairing is displayed.
is displayed when you are done.
ID Polar H7 xxxxxxxx
is displayed. Choose Yes.
Polar RUN/CAD/SPD xxxxxxxx
24
and press START.
is displayed.
and press START.
is displayed.