Display G Functions, Transformations And Swivel Data Record - Siemens SINUMERIK 840D Operator's Manual

4
03.04
Auxiliary
functions
References

4.2.7 Display G functions, transformations and swivel data record

Transform./
G functions
or
References
Swivel data status display Precondition:
References
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
4.2 General functions and displays
The "Auxiliary functions" window appears on the screen.
Up to 3 M functions or 3 H functions can be displayed.
/PG/Programming Guide Fundamentals
Function
Active G functions and transformations can be displayed in the active
channel.
Operating sequence
"AUTO"/"MDA"/"Jog" mode is selected in the "Machine" operating
area.
The window "Transform. + G functions" with the active G functions
and transformations is displayed.
Using the "Page" keys you can scroll up and down to display other G
functions.
Further information
Every G group has a fixed location.
The group number (no.) and the current G function of the G groups
are displayed only if a G function is active.
/PG/Programming Guide Fundamentals
The swivel function (CYCLE800) has been set up by the machine
manufacturer.
The active swivel data record (orientable toolholder TOOLCARRIER)
is displayed concurrently with the transformations.
The following values are displayed:
TCARR = 1 .. n*
/PGZ/Programming Guide Cycles: Chapter 3 "Swiveling"
Machine Operating Area
*n max. no. of set swivel
data (TOOLCARRIER) that are active.
4
4-79